Micromod MOD: 30ML Functions Data Base Reference Manuel d'utilisateur télécharger pdf (Page 104)

MOD 30ML Functions

CONFIGURATION EXAMPLES

 A loop compound is a compound or group that contains a loop block. You configure other

blocks and compounds inside the loop compound. The compound can be added to one of

the five scan groups defined in the Interface block. All the blocks inside the compound will

be executed at that scan rate.

• The compound will also have a Compound Signals menu that can be used to make pre-

defined connections in and out of this block. (We will not use this for now. You can close it by

clicking on the close button on its right hand side top – the X button)

8. Open the Loop block (LP-1) by double-clicking on it. The block will open as shown in the

next figure. We will not change anything in this block. Just notice that scan group this

compound belongs to defaults to Scan Group 1. (200 ms– refer to step 4 - Interface block).

Figure 3. 15. Loop Block

Close the Loop block by clicking on the OK button.

9. Add the ML_PID compound from the Component Gallery:

• From the top menu bar, select Project/Gallery/Component Gallery

3-10

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 151 152

Pas de commentaire

Micromod MOD: 30ML Functions Data Base Reference Manuel d'utilisateur Page 104