Micromod Micro-DCI: 53SL5100A Single Loop Controller Manuel d'utilisateur télécharger pdf (Page 98)

Single Loop Process Controller Instruction Manual

90 Automatic/Manual Station

8.3 Automatic/Manual Station Parameter Selections

Figure 8-4 illustrates how a Single Loop Controller might appear with only the default values and power

applied, but no analog input or output signals. In Figure 8-4, ANO0 (TB1-lO) is jumpered to ANI0 (TB1-2)

to simulate process operation. The unit has the AC power supply and power cord 173D109U03. Connect-

ing ANO0 to ANI0 is done only for illustration purposes and is not necessary to configure the controller. If

the controller is connected to a Datalink network, then assign the Instrument Address (8001) and Baud

Rate (8002) first so the remaining datapoints may be entered at the SUPERVISOR-PC unit. After this sec-

tion, refer to Section 9 to configure the parameter display datapoints. The parameter display is accessed

by pressing the F2 push button from this display. All other datapoints not shown in the illustration are at the

default value.

Figure 8-4. CS4 Datapoint Selections

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 151 152

Pas de commentaire

Micromod Micro-DCI: 53SL5100A Single Loop Controller Manuel d'utilisateur Page 98