Micromod Micro-PWC: 53PW6000 MicroPWC Configuration Guide Manuel d'utilisateur télécharger pdf (Page 191)

Micro-PWC CONFIGURATION GUIDE

Grafx Editor 171

4.4.3.6 FP_DYput1pb

The submodel FP_DYput1pb (Figure 4-46) is a pushbutton which, when pressed, writes a numeric value

or ASCII character into one controller database point. The following example shows an instance of

FP_DYput1pb configured to start the motor MCV-R01A01 (DCD module) when the button is "pressed"

(clicked on).

Position the pointer on the submodel and click the right mouse button, then click on the Configure Sub-

model item on the resulting pop-up menu. The Submodel Configuration window for the PUT1 Pushbutton

Submodel will appear will appear (Figure 4-47).

Variables

✎ Note FP_DYput1pb is basically a simpler version of FP_DYputpb, and

can be used in cases where one value is to be written to one

controller database point. (FP_DYputpb allows up to four values to

be written to as many as four controller database points.)

Figure 4-46. Put1 Pushbutton Submodel (FP_DYput1pb)

Figure 4-47. Put1 Pushbutton Configuration Window

button_label Enter the label to be displayed on the button (e.g., Start).

Default: None

put_tagatom Enter the Tag.atom of the controller database point to which the data

configured in put_value will be written (e.g., MCV-R01A01.INB).

Default: None

put_value Enter the value that will be written to the controller database point configured

in put_tagatom (e.g., 1).

Default: None

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 367 368

Pas de commentaire

Micromod Micro-PWC: 53PW6000 MicroPWC Configuration Guide Manuel d'utilisateur Page 191