Micromod MOD: 30ML Controller Operation and Maintenance Tra Manuel d'utilisateur télécharger pdf (Page 53)

Training Manual

MOD 30ML Diagnostics Lab

4 - 5

2 Press DOWN key once. If

PASSWORD is not displayed on line 2,

go to step 5. Otherwise continue

with Step 3.

3 Use UP key three times to select the

PASSWORD and then use ENT to

enter. See the next set of figures

Lines 1 and 2 will display CURRENT LEVEL and

Line 6 will display CONFIG indicating that the

controller is in configuration mode.

4 Press ENT again to enter

Configuration mode.

Lines 1 and 2 will display DEV STATE and

INSTATE (Instrument state). Line 6 will display RUN

indicating that the controller is running a valid

database.

Figure 4 .4.

5 Press the NXT key until COMMANDS

is displayed on line 2.

You will be in DEV STAT menu mow. See the

sequence of figures below:

You can issue commands to the controller from

this menu.

Figure 4 .5.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 73 74

Pas de commentaire

Micromod MOD: 30ML Controller Operation and Maintenance Tra Manuel d'utilisateur Page 53