Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Manuel d'utilisateur télécharger pdf (Page 38)

3.2.5 CONFIGURE A MODULE

The navigational sequence would be the following

•

Select Module Type (then Module, if there’s more than one Module)

•

Select Page (Skipped when there’s only a single page)

•

Select Parameter

3.2.5.1 Module-Mode ConfigurationProcedure

•

Press the

Mode

button to enter ENGINEER mode

indicated by the appearance of either

CONFIGURE

DISPLAY

PROGRAM

at the bottom of the display..

•

CONFIGURE

does not appear, press F2 until

CON-

FIGURE

appears at the bottom of the display.

•

When

CONFIGURE

is displayed, press F3 to enter the

CONFIGURE

mode.

•

For a Hi-Res display, as shown, press F2 until

MOD-

ULE

appears at the bottom of the display.

•

When

MODULE

is displayed, press F3 to enter the

MODULE

mode.

•

The screen should now appear as shown on the right.

•

Select the desired MODULE type to be configured by

using the keys to navigate to the desired mod-

ule type.

•

In this example, the button was used to navigate to

the

CONTROL

module type as shown to the right.

•

Press F3 to select this Module type.

MODULAR CONTROLLER QUICK START

3-13

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller