Micromod MOD: Remote I/O Modules for use with 2020N Remote Manuel d'utilisateur télécharger pdf (Page 6)

Remote I/O Modules

PRODUCT DESCRIPTION

1.2 BASIC HARDWARE

The descriptions included in this section give a brief overview of the functions and features of

the basic hardware used to install remote I/O capabilities.

1.2.1 2020N Remote I/O Interface Module

One Remote I/O Interface Module is required for each Remote I/O Network to be connected

to the host instrument. The RIO module may be placed in any slot on the instrument. One

RIO block is used to configure an RIO module in the Application Builder. Remote I/O

modules are scanned every 50ms.

Catalog Number: 2020NZ10000A Remote I/O Interface Module (product is serialized)

1.2.2 ECZ Remote I/O Module Carrier

Each remote I/O module is mounted on a Module Carrier, plug-in base which contains signal

terminations, address switch and mounting plate. The module carrier can be DIN or surface

mounted. Remote I/O modules provide status and error LEDs, a diagnostic test button, and

are available for 24VDC, 120VAC or 220VAC power supply.

Catalog Number: ECZ Remote I/O module Carrier (product is not serialized)

1 2 3 4 5 6 7 8 9 10 11 ... 41 42

Pas de commentaire

Micromod MOD: Remote I/O Modules for use with 2020N Remote Manuel d'utilisateur Page 6