Micromod MOD: MODCELL Multiloop Processor 2002N Model C and Manuel d'utilisateur Page 43

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 42
MODCELL Multiloop Processor
ELECTRICAL CONNECTIONS
3.5.6 2009A RTD Input (RIM, WRIM)
Make resistance input connections to terminal block as shown in Figure 3-8. The 2 wire
input module (RIM) uses a single wide case and the 3 wire input module (WRIM) uses a
double wide case. Table 3-2 summarizes the RTD support standards and shows some
sample RTDs.
Table 3-2. Supported RTD Materials and Standards and Sample RTDs
1. Also meets IEC 751 and BS 1904 Standards.
2. Sometimes called U.S. Industrial Standard.
Sample RTDs and Appropriate Module
ohms
@ 0°C
Approx. ohm
Range
RTD Module
Supported RTD Materials and Standards
Material
Alpha
(ohm/ohm/°C)
Standard
1000 184.94 to 3902.61 2 Wire Platinum 0.003850 DIN 43760 (Note 1)
500 92.47 to 1951.31 2 Wire Platinum 0.003850 DIN 43760 (Note 1)
1000 555.00 to 3169.25 2 Wire Nickel 0.006720 Minco (Note 2)
100 18.49 to 390.26 3 Wire Platinum 0.003850 DIN 43760 (Note 1)
98.129 16.66 to 311.87 3 Wire Platinum 0.003923 SAMA RC21-4
100 17.07 to 332.62 3 Wire Platinum 0.003902 Burns
100 17.26 to 403.70 3 Wire Platinum 0.003911 Minco (Note 2)
120 66.60 to 380.31 3 Wire Nickel 0.006720 Minco (Note 2)
Input specifications for the 2 wire and the 3 wire input modules are:
RTD INPUT
Range (0 t o100%):
2 Wire: 0 to 4000 Ohms
3 Wire: 0 to 400 Ohms
Low limit: 0 Ohms
High limit:
2 Wire: 4200 Ohms
3 Wire: 400 Ohms
Module Counts (0 to 100%): –25000 to 25000 (converted to 0 to 50000 in controller)
Sensitivity (One Count)
2 Wire: 0.08 Ohms
3 Wire: 0.008 Ohms
Accuracy, calibrated at 5V supply and 25°C: ±0.05% of Range
(This equals an absolute accuracy of ±25 counts or ±2 ohms for the 2 wire input or
±0.2 ohms for the 3 wire input or ±0.519°C for the Platinum DIN 43760 curve)
Temperature Effect (0 deg C to 50 deg C): 0.1% of Range
Noise filter: 3 db at 5 Hz
Max Resistance Each Lead: 100 Ohms
Excitation Current (maximum)
2 Wire: 0.25 mA
3 Wire: 0.6 mA
Burnout Detection on all leads: Upscale
Isolation: 250 Vrms
Common mode rejection: 100 db at 60 Hz minimum
Normal mode rejection: 40 db at 60 Hz minimum
37
Vue de la page 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 81 82

Commentaires sur ces manuels

Pas de commentaire