Micromod MOD: 30ML Operation and Template Setup Manuel d'utilisateur télécharger pdf (Page 42)

MOD 30ML Multiloop Controller

OPERATION

3-10

3.9.1 Single Loop Automatic Operation with Local Set-Point

When a control loop is configured for single loop operation with local set-point, the front panel

displays and control key operations resemble the examples below.

[AUT] indicates that the controller is in automatic

mode.

[LOC] indicates local set-point. R/L key is disabled.

[SP] indicates that the current set-point value is

displayed on Line 6 (bottom line). An engineering units

label has been configured for the value.

∇/∆ arrow display indicates that set-point can be

changed in automatic.

Press ∇ or ∆ to change set-point.

Press the scroll key to display the output in percent on

Line 6.

[OP] appears on Line 5 indicating that Line 6 is

showing the current output value.

∇/∆ arrow display disappears since output cannot be

changed in automatic.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Pas de commentaire

Micromod MOD: 30ML Operation and Template Setup Manuel d'utilisateur Page 42