Micromod MOD: 1750N Output holder for MOD 30ML Manuel d'utilisateur télécharger pdf (Page 12)

Output Holder Instructions

MECHANICAL INSTALLATION

• The panel provides rigid support for a fully loaded 5.5-pound (2.5 kg) controller and any

other panel devices.

• Electrical wiring routing and support are planned.

Mount the output holder as follows:

1. Prepare the panel as indicated in Figure 2-1.

2. Slide instrument into panel cutout.

3. Insert brackets into slots in top and bottom of instrument housing.

4. Tighten retaining screws to a torque of 5 inch-pounds (0.6 Nm) or 1-1/2 turns after

contact is made with the back of the panel.

MOUNTING DIMENSIONS

Figure 2 .1. Output Holder Mounting Dimensions

2 -2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Pas de commentaire

Micromod MOD: 1750N Output holder for MOD 30ML Manuel d'utilisateur Page 12